OrnamentalRoseEngine.com
Rose Engine
-Fabrication notes 7/2/08
   Prototype:
- Prototype Rose Engine
- Rubber & rosette cam
   Construction:
- Turning the index wheel
- Drilling the index wheel
- Cutting a Rosette cam
- Fabricating T-nut
- Spindle stop
- Rubber assembly
- Spindle & bearings
- Pivot axle & bearings
- Spindle & frame
- Index wheel installed
- Rocking stop arm
- Rose Engine ready to test
- Chuck holding work
- Turn aluminum on wood lathe
- Hand crank and handle
- Threading follower
- Copy a cam
- Drilling a cam
- Finished rosette cam
- Router assembly
- Boring bar cutters
- Chuck adjusting Spider
- Overhead drive 4/15/08
- Cutting frame 4/15/08
- Rose Engine 2/8/08
- Rose Engine latest 2/17/08
- Test results - Gallery
   Notes:
- Description of a Rose Engine
       by Jon Magill
   Other Stuff:
- Wood Lathe works
- Shop jigs homemade
- Downloads & plans
E-mail:
info1@OrnamentalRoseEngine.com
Fabricating a Rosette Cam -cam02.jpg 640x430 - 53.6k
Custom Rose Engine & Ornamental Lathe
Drilling a Rosette Cam for the Rose Engine

The 9" diameter rosette cam has been centered on the rotary table on the milling machine and the center hole bored to the correct size. The quarter phase index holes are being drilled to allow phase adjustments. This larger cam can be rotated quite a bit faster than the original 6.5" diameter rosette cam.

1x3 bar_rust.gif
Rose Engine Rose Engine barleycorn design barley10.jpg 65x65-2.7k
           OrnamentalRoseEngine.com
E-mail: info1@OrnamentalRoseEngine.com